P0155 OBD Trouble Code
4 results found
| Type | Powertrain - Fuel and Air Metering - ISO/SAE Controlled |
|---|---|
| Description | O2 Sensor Heater Circuit |
| Location | Bank 2 Sensor 1 |
| Type | Powertrain - Fuel and Air Metering - ISO/SAE Controlled |
|---|---|
| Description | HO2S Heater Circuit Conditions |
| Location | Bank 2 Sensor 1 |
| Cause | Engine at idle after a cold startup, ECT sensor input less than 147°F, BTS ambient air input at ±59°F of ECT input, then test started and the PCM detected that the left front HO2S-21 signal was over 300 mv for 30-90 seconds. |
| Type | Powertrain - Fuel and Air Metering - ISO/SAE Controlled |
|---|---|
| Description | HO2S Heater Circuit Conditions |
| Location | Bank 2 Sensor 1 |
| Cause | Engine running for 1 minute, then the PCM detected an open or short in the HO2S heater circuit |
| Type | Powertrain - Fuel and Air Metering - ISO/SAE Controlled |
|---|---|
| Description | HO2S Heater Circuit Conditions |
| Location | Bank 2 Sensor 1 |
| Cause | No CKP, ECT, EGR, EVAP, Fuel Trim, Fuel Injector, IAT, MAP, Misfire or TP sensor codes set, system voltage 8-18v, ECT and IAT inputs less than 95°F and within 11°F of each other at startup, average MAF sensor less than 20 g/sec, then the PCM detected the HO2S-21 signal remained within 150 mv of bias voltage during the test period (time varies between 42 seconds and 2 minutes) |
Try also: https://www.obd-codes.com/p0155
