P0440 OBD Trouble Code
4 results found
| Type | Powertrain - Auxiliary Emission Controls - ISO/SAE Controlled |
|---|---|
| Description | Evaporative Emission System |
| Type | Powertrain - Auxiliary Emission Controls - ISO/SAE Controlled |
|---|---|
| Description | EVAP Purge System Fault Conditions |
| Cause | Engine at idle speed, ECT sensor input over 170°F, then the PCM commanded the EVAP solenoid open and closed and detected that the change in fuel compensation and in the IAC motor position were below a predetermined range |
| Type | Powertrain - Auxiliary Emission Controls - ISO/SAE Controlled |
|---|---|
| Description | EVAP System Fault Conditions |
| Cause | Cold start warm-up completed, engine running in closed loop at steady state conditions, then the PCM detected insufficient EVAP system flow with the solenoid energized |
| Type | Powertrain - Auxiliary Emission Controls - ISO/SAE Controlled |
|---|---|
| Description | EVAP System Fault Conditions |
| Cause | No ECT, FTP, IAT, MAP or TP sensor codes set, DTC P0443 and P0449 not active, system voltage 10-18v, BARO input more than 75 kPa, ECT and IAT sensor inputs from 39-884° F at startup, IAT input not more than 7°F higher than the ECT input at startup, ECT input not more than 14°F higher than the IAT input at startup, fuel tank level between 15-85%, IAT input less than 86°F, VSS input less than 80 mph, then the PCM detected that the EVAP system was unable to achieve or maintain vacuum during the test period |
Try also: https://www.obd-codes.com/p0440
